全国服务热线
15552522412 
联系我们
济南圣果清洁服务有限公司

联系人:田经理

联系电话:15552522412 

网址:http://www.sggdst.com

地址:济南市天桥区北园大街248号二楼西侧间

当前位置: 首页 > 新闻中心 > 公司新闻 >

化粪池吸污车工作的操作流程!

来源:http://www.sggdst.com  发布时间:2019-08-24 16:07:35

现在的化粪池清理,很多的机器都提供了极大的方便,化粪池吸污车就是其中的一种!下面济南化粪池清理公司就给大家普及一下吸污车的操作流程,希望对大家有所帮助!
Now septic tank cleaning, many machines have provided great convenience, septic tank suction truck is one of them! The following Jinan septic tank cleaning company will popularize the operation process of the suction truck, hoping to help you!
1.吸污车作业前准备
1. Preparations for suction truck before operation
吸污车后部尽量接近作业点,驻车。将回油箱直通旋塞旋柄扳至与进油管轴线呈45°左右夹角,观察进油管,应有润滑油流动。打开走台箱边门,取出吸污胶管,使之向后摆动,无弯折现象。
The rear of the suction truck should be as close as possible to the operation point and stop. Pull the cock handle of the return tank through the cock at an angle of about 45 degrees to the axis of the oil intake pipe. Observe the oil intake pipe, and there should be lubricating oil flow. Open the side door of the tray box and take out the suction hose to make it swing backward without bending.
2.抽吸作业
2. Suction operation
将吸污胶管尽可能深的抽入污液,保证管端在作业过程中始终距液面300mm以下。将四通阀手柄推至与地面垂直。变速器挂入空挡,然后起动发动机,分离离合器,将取力器开关向后拉即挂档取力,真空泵开始运转。打开驾驶室内工具箱,拉出讯响器开关,接通其电源。操作员可通过后封头上部的观察镜,当液面达到观察镜中部时,应通知驾驶员,同事应迅速将吸污胶管拉离地面或关闭四通阀。在正常情况下,讯响器此时会发出声光讯号,驾驶员接收到信号应减小油门,将取力器开关向前推卸脱档,真空泵停止动转,按入讯响器开关,切断其电源。
The suction hose is sucked into the sewage as deep as possible to ensure that the end of the pipe is always below 300 mm from the liquid level during the operation. Push the four-way valve handle vertically to the ground. The transmission is put into neutral gear, then the engine is started, the clutch is separated, the power take-off switch is pulled backward, and the vacuum pump starts to run. Open the cab toolbox, pull out the loudspeaker switch and turn on its power supply. Operators can use the observation mirror on the upper part of the rear head. When the liquid level reaches the middle part of the observation mirror, the driver should be informed that the colleagues should quickly pull the suction hose off the ground or close the four-way valve. Under normal circumstances, the loudspeaker will send out acoustooptic signals at this time. When the driver receives the signal, he should reduce the throttle, push the power take-off switch forward and off-gear, stop the vacuum pump, press the switch into the loudspeaker, and cut off its power supply.
济南化粪池清理
将加油箱直通旋塞旋柄板与进邮箱轴线平行即关闭。冲洗胶管后,将其放回走台箱,关好边门,并使吊杆朝向驾驶室上方。关闭防溢阀,使其手柄与路轴线垂直即可。将吸污车驶离作业点。
Close the filling tank directly through the cock handle plate parallel to the axis of the incoming mailbox. After flushing the hose, put it back into the cab, close the side door, and make the boom toward the top of the cab. Close the relief valve so that the handle is perpendicular to the road axis. Drive the suction truck away from the operating point.
3.排卸作业
3. Disposal and unloading operations
将吸污胶管朝向蓄污池内。
Turn the suction hose into the reservoir.
将四通阀门后柄拉至与地面平行,开启防溢阀,使其手柄与管路轴线平行即可。
The rear handle of the four-way valve is pulled parallel to the ground, and the relief valve is opened so that the handle is parallel to the pipeline axis.
将变速器挂入空挡,然后起动发动机,分离离合器,将取力器开关向后拉即挂档取力,真空泵开始运转,将变速器挂入空挡,然后起动发动机,分离离合器,将取力器开关向后拉即挂档取力,真空泵开始运转。
Put the transmission into neutral gear, then start the engine, separate the clutch, pull the power take-off switch backwards, and then the vacuum pump starts to run. Put the transmission into neutral gear, then start the engine, separate the clutch, pull the power take-off switch backwards, and then the vacuum pump starts to run.
本文来自:济南化粪池清理,更多的内容请点击:http://www.sggdst.com!我们将会为您提问的问题提供一个满意的服务,欢迎您的来电!
This article is from: Jinan septic tank cleaning, more content please click: http://www.sggdst.com! We will provide you with a satisfactory service to ask questions. Welcome your call!